#
# Makefile for loongson based machines.
#
obj-y += setup.o init.o cmdline.o env.o time.o reset.o irq.o \
pci.o bonito-irq.o mem.o machtype.o platform.o
obj-$(CONFIG_GPIOLIB) += gpio.o
#
# Serial port support
#
obj-$(CONFIG_EARLY_PRINTK) += early_printk.o
obj-$(CONFIG_SERIAL_8250) += serial.o
obj-$(CONFIG_LOONGSON_UART_BASE) += uart_base.o
obj-$(CONFIG_LOONGSON_MC146818) += rtc.o
#
# Enable CS5536 Virtual Support Module(VSM) to virtulize the PCI configure
# space
#
obj-$(CONFIG_CS5536) += cs5536/
#
# Suspend Support
#
obj-$(CONFIG_LOONGSON_SUSPEND) += pm.o
|